You are currently viewing Chevy Silverado Remote Start Not Working

Chevy Silverado Remote Start Not Working

Chevy Silverado Remote Start Not Working. Remote start system not working on chevy silverado hd. The turn signal lights flash multiple times and the engine starts.

How To Remote Start Chevy Silverado 2020 at Start
How To Remote Start Chevy Silverado 2020 at Start from imagoscansource.com

You need to have the vehicle serviced and have the code cleared in order for remote start to function properly again. • a 100 ohm variation in the passlock™ sensor signal wiring circuit, circuit 1836. Hit the lock button once, then hold the remote start button (usually shaped like an arrow ) for at least 2 seconds or until the turn signal lamps flash.

Remote Start System Not Working On Chevy Silverado Hd.

The situations of a disabled remote start are explained in the owners manual, and have been in place since at least 2008, when i had it on my 1st 2000+ new vehicle purchase. Now press your remote start button on the remote. • a 7 ohm variation in the sensor ground circuit wiring, circuit 1057.

Press The Lock Button On The Key Fob Of Your Silverado.

You may have to hold the remote start button for up to 5 seconds. It’s actual stored data that would point towards what is telling the ecm to not remote start. • broken wiring inside the insulation.

Yes, The Remote Start Is Disabled With A Cel.

I believe mine is happening due to the coolant heater being too close to a sensor in the rad or something like that. Your remote start will only run for 10 minutes at a time. Edited november 8, 2016 by redwngr

It Can Only Be Had With A High End Or Gm Scan Tool.

If it works, your chevrolet silverado has a remote start. Maybe the hood sensor position is incorrectly set, or there is a loose connector on that circuit. Keep holding and the vehicle should start.

The Hood On Your Silverado Hd Is Not Fully Closed.

Get the engine light fixed and remote start will start working again. The system is disabled due to the engine light being illuminated. Once this is on, your remote start won't work until it is cleared, either by a code reader or disconnecting your battery.

Leave a Reply