How To Reset Xfinity Cable Box Rng150N. After the box power cycled it. Turn on the tv and the decoder.
I would swap it first if it just wont power on. When i plug power into the box, the front 3 lights cycle, then the power light blinks 12 times then goes out and a red light on the back for optical audio out stays on. They sent two rng150n boxes.
Xfinity Just Sent Rng150N For X1.
To do this, enter the tv's on screen menu and select picture, then advanced video, then set overscan to off and exit the menu. When i plug power into the box, the front 3 lights cycle, then the power light blinks 12 times then goes out and a red light on the back for optical audio out stays on. I recently talked with cs about switching from regular to x1.
Of The Four Cable Boxes, The Xg1 Models Have Dvr Capability While The Other Two Do Not.
Wait 3 to 5 minutes for the box to reset. Power supply is probably dead. It seems this is an old box and now i'm wondering if i should consider this a slap in the face.
I Picked Up Pr150Bnm At The Local Comcast Store As A X1 Box Which Comes With The Component Input.
Reconnect the power cord to the cable box. You will need adobe acrobat reader to view the information. Comcast has also released the pace xi3 cable box in some test markets that has no dvr capability and can only output signals through hdmi.
Turn On The Tv And The Decoder.
When it was plugged in i was getting the local channels in hd. Select your preferred method and press start troubleshooting. They sent two rng150n boxes.
You May Also Adjust Your Cable Box Output Settings To Send A Signal Compatble With Your Tv By Changing The Video Output To Widescreen Or 16:9 Pillarbox.
If you select device restart, you will be taken to the tv box selection screen. After the box power cycled it. I've also tried holding to power button for 10+ seconds, reconnecting the power cable to the same result.